Tubing Care - Medela symphony Manual De Instrucciones

6. Tubing Care

Supplies needed:
• Mild dish soap
• Clean dish towel
• Clean sink or bowl
• Drinking quality water
• Damp (not wet cloth)
Parts needed:
• Tubing
• Symphony pump
®
• Membrane cap
• Protective membrane
3
Remove tubing, protective
membrane, and membrane cap.
Clean following steps in section 4.
Warning
Breastpump kits are a personal
care item intended for use by a
single user only and should not
be shared between users.
12
Caution
• Do not store wet or damp parts as mold
may develop.
• If tubing becomes moldy, discontinue
use and replace tubing. Contact Medela
Customer Service at customer.service@
medela.com or call 1-800-435-8316.
• Inspect tubing after each pumping
session.
Note
Only wash tubing if condensation or
milk is present.
4
Remove tubing from
breastshield.
Warning
Refer to breastpump instructions
for use for important safeguards
and operating information.
1
Turn off breastpump.
5
Rinse tubing in cool water to
remove breastmilk.
Questions? Visit www.medela.com or call us at 1-800-435-8316.
2
Unplug breastpump from
power source.
6
• Wash tubing in warm soapy water.
• Rinse tubing with clear water.
• Hang to air dry or shake out any
drops of water from the tubing
and let the pump run with tubing
attached for 1-2 minutes until dry.
13