7. Assembly of Pump Kit
T
Tip
Carry out all the steps with care and
assemble the pump kit correctly for
optimum performance.
Parts Needed:
• Tubing
• Symphony
pump
®
• Breastshields
• Breastmilk bottles/containers
• Lids
• Connectors
• Valves
• Membranes
• Membrane cap
• Protective membrane
Note
• Use Authentic Medela Spare Parts
only. See page 5 for details.
• Check pump kit components for
wear or damage before use and
replace if necessary.
• All components must be completely
dry before use for proper
performance and to prevent
damage to the pump.
14
1
Caution
Wash hands thoroughly with soap and
water before touching breastpump, kit
and breasts. Avoid touching the inside
of containers or lids.
4
Push yellow valve onto inner
ring of connector bottom.
7
Place the protective membrane
onto a fl at surface and carefully
push the membrane cap down
until it engages.
2
Carefully snap membrane onto
yellow valve until membrane
lies fl at.
5
Screw connector onto the
bottle/container.
8
Insert the tubing adapter into
the opening in the membrane
cap.
Questions? Visit www.medela.com or call us at 1-800-435-8316.
3
Push the breastshield onto
the connector.
6
Insert the tubing into
the corresponding opening
in the connector.
Warning
Refer to breastpump instructions
for use for important safeguards
and operating information.
15