Assembly; Unpack Generator; Attach Negative Battery Cable; Install Wheel Kit - Briggs & Stratton PGMA G200 Manual Del Operador

Assembly

Your generator requires some assembly and is ready
for use after it has been properly serviced with the
recommended fuel and oil level is verified.
If you have any problems with the assembly of
your generator, please call the generator helpline
at (800) 743-4115. If calling for assistance, please
have the model, revision, and serial number from the
identification label available.

Unpack Generator

1. Set the carton on a rigid, flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner
from top to bottom.
4. Leave generator on carton to install wheel kit.
The generator is supplied with:
• Operator's manual
• Battery float charger
• Wheel kit
• Keys (2)

Install Wheel Kit

NOTICE Wheel kit is not intended for over-the-road use.
You will need the following tools to install these
components:
• 13 mm and 19 mm wrench
• Socket wrench with 10 mm and 16 mm sockets
Install the wheel kit as follows:
1. Tip generator so that engine side is down.
2. Slide axle stud (A) through mounting bracket with
threaded end facing out.
B
3. Insert retaining pin (B) through hole on axle stud.
4. Slide a wheel (C) over axle stud.
NOTICE Be sure to install wheel with raised hub inboard.
5. Attach wheel to axle stud with a washer (D), lock
washer (E) and nut (F). Tighten with a 16 mm
socket wrench and 19 mm wrench.
6. Place hub cap (G) into center of wheel and push
until it snaps into place.
7. Repeat steps 2 through 6 to secure second wheel.
C
A
D
F
E
G
8. Line up holes in support leg (H) with holes in
generator frame.
H
9. Attach support leg using 4 capscrews (J) and 4
hex nuts (K). Tighten with a 10 mm socket wrench
and 13 mm wrench.
10. Return generator to normal operating position
(resting on wheels).

Attach Negative Battery Cable

Your unit is equipped with electric start capability but
can be started manually. If you choose not to use the
electric start feature, you do not need to connect the
negative battery cable.
The sealed battery on the generator pre–installed
except for the negative (black) battery cable.
WARNING Battery posts, terminals and related
accessories contain lead and lead compounds -
chemicals known to the State of California to cause
cancer and reproductive harm. Wash hands after
handling.
To install:
1. Cut off tie wrap securing loose end of negative
(black) cable.
2. Using 8 mm or 5/16" wrenches, remove nut (L),
lock washer (M) and flat washer (N) on negative
battery terminal (—).
L
N
P
3. Slide negative battery cable (P) over screw (Q) on
negative terminal.
4. Reattach washer and nut and tighten.
5. Verify that connections to battery and generator
are tight and secure.
NOTICE If your battery is discharged, charge prior
to use following the instructions in the section Battery
Charger.
J
K
Q
9