Elixo 500 24 V
Fitting the end limit brackets
[1]
Manually move the gate to the open position.
[2]
Position a bracket onto the rack so that it activates the motor end limit contact.
[3]
Screw the bracket onto the rack.
[4]
Manually move the gate to the closed position then repeat steps 2 and 3 to fi t
the second bracket to the rack.
Wiring
General wiring diagram
Terminals
Description
1-2
A-B
3-4
0V-24V~
5
COM
6
SWC
7
SWO
8-9
10
ANT
11
ANT
12-13
24 V~/---
14-15
SCA
16-17
24 V~/--- (V Safe)
18
FAULT
19
COM
20
PED
21
COM
22
START/CLOSE
23
STOP
24
PHOT
25
BAR
26
OPEN
31-32
33
N
34
L
Aerial wiring
For optimum reception, the aerial must not be cut
and must be as far away as possible from the power
supply terminal blocks and wires. The aerial must
always be installed at a height and must be visible
from a distance.
Do not fi t the aerial to a metal post or behind a wire
fence.
Cut the coaxial cable if it is too long. Shortening the
cable will improve the signal (a coaxial wire which is
too long, extended or connected with an insulating
screw joint will distort the signal).
The mounting plate is an active component of the
aerial. It must not be removed or modifi ed.
6
Function
Motor connection
Secondary transformer
Shared by end limit contacts
Closing end limit contact
Opening end limit contact
24 V output, fl ashing orange light
Aerial core
Aerial braid
Alternating 24 V output for power supply to the additional devices
Gate status indicator output (open/closed)
Alternative 24 V output for power supply to, and autotest of, safety devices
Input for safety devices autotest
Shared by control inputs (18-20)
Pedestrian opening control point input
Shared by control inputs (22-23-24-25-26)
Sequential operation control point input (adjustable in the LoGic menu, see pg.11)
Control point input (closing only)
Photoelectric cell input
Safety edge sensor input
Opening control point only
Primary transformer 230 V~
Neutral single-phase 230 V~, 50-60 Hz power supply
Live single-phase 230 V~, 50-60 Hz power supply
a
b
SX
5 mm
15 mm
Copyright © 2008 Somfy SAS. All rights reserved.
DX
a
b
10
11
P2