Tabla de contenido
Publicidad
13.2.1 Tailstock adjustment
Move the tailstock (5) by loosening the lock lever (1) and pushing the tailstock to the
desired position on the bed. Lock by tightening the lock lever (1).
The spindle can extend up to 2 1/2" from the tailstock housing. You can move the tailstock
spindle (4) by loosening the spindle lock lever (2) and then turning the hand wheel (3).
Turning the hand wheel clockwise extends the spindle; turning it counterclockwise retracts
the spindle. Lock the lock levers (1) and the spindle lock levers (2) before operating the
lathe.
The tailstock spindle is hollow and can be accessed from the handwheel end. Use the push-
out rod to remove the center cup or to drill holes through the center of a workpiece on a
faceplate.
13.2.2 Tool rest adjustment
To move the tool rest base (1), loosen the lock lever (4) and
move the base to the right or left and back or front. Tighten the
lever (4) when the tool rest base is in the desired position.
To adjust the angle of the tool rest (2), loosen the lock lever (3),
move the tool rest to the desired position, and tighten the lock
lever.
To change to the other tool rest, loosen the lock lever (3) and
pull the tool rest (2) out of the tool rest base, insert the other
tool rest, adjust to desired position, and tighten the lock lever
(3).
The tool rest should be selected as close as possible to the workpiece!
Height adjustment just below the centerline of the workpiece.
Rotate the workpiece by hand and check that the workpiece can rotate freely before
turning!
13.2.3 On-Off-switch
Switch on: Push the green button ("I") for 2 seconds. The machine begins to run.
Switch off: Push the red button ("0").
The machine does not stop immediately! Stay as long at the machine, until the workpiece is
completely stopped (Do not stop the workpiece by hand!)
HOLZMANN MASCHINEN GmbH
N O T I C E
www.holzmann-maschinen.at
13.2
Operation
D 460FXL
33
Publicidad
Tabla de contenido
Solución de problemas
