Assembly; Lock Lever; Face Plate; Spur Center - HOLZMANN MASCHINEN D 460FXL Manual De Instrucciones

Do not use solvents based on nitrite, aggressive solvents like break cleaners
or scrubbing agents!
These damage the machine surface.
The machine is delivered pre-assembled.
For transport reasons some parts of the machine can be assembled by the customer.

12.2.1 Lock lever

This lever has to be mount at the headstock and the tool rest.
The shoulder screw (1) passes through the spring (2) and the
handle lever (3). If either lock lever has come loose from the
lathe or has come apart in shipping, reassemble it and thread
into place.
To operate, push the handle lever in and turn clockwise to
tighten. Pulling the handle lever outward will disengage the
threaded shaft, allowing you to reposition the lever handle so it is
out of the way.

12.2.2 Face plate

Thread the faceplate (1) onto the end of the headstock spindle and
hand tighten. Place the wrench (2) over the flats on the faceplate.
Insert the tip of the push-out rod (3) into one of the slots in the
side of the headstock spindle. While gripping the push-out rod
firmly, turn the wrench to either tighten or loosen the faceplate.
Remove the push-out rod and wrench. If the faceplate is being
removed, continue turning it until it comes off the spindle threads.
Do not operate the lathe until it is completely assembled and adjusted
according to the instructions.

12.2.3 Spur center

Insert the tailstock cup center (1) into the hollow center of the headstock
spindle.
Insert the shaft (1) of the tailstock center into the hollow center of the
tailstock spindle.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O T I C E
12.2
WARNING

Assembly

30
D 460FXL