Maintenance; Maintenance Plan - HOLZMANN MASCHINEN D 460FXL Manual De Instrucciones

14

MAINTENANCE

Don't clean or do maintenance on the machine while it is still
connected to the power supply:
Damages to machine and injuries might occur due to unintended
switching on of the machine!
Therefore: Switch the machine off and disconnect it from the
power supply be-fore any maintenance works or cleaning is carried
out
The machine does not require extensive maintenance. If malfunctions and defects occur, let it
be serviced by trained persons only.
Before first operation as well as later on every 100 operation hours you should lubricate all
con-necting parts (if required, remove beforehand with a brush all swarfs and dust).
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the machine.
The good condition and perfect adjustment of the guiding rollers is essential for a smooth band
guidance and a clean cut.
Store the machine in a closed, dry location.
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a
pre-requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
After each workshift:
Clean the machine and its parts with a strong jet of compressed air from wood dust and other
material remains. Moving parts can also be cleaned with a brush or a soft brush. Apply a thin
layer of lubricating oil to all moving parts of the machine.
After 50 hours of operation
Check the V-belts.
Determine for frayed belts cause. Check if uneven or rough surfaces and were built on the V-
belt pulleys. Replace frayed or stretched belts!
HOLZMANN MASCHINEN GmbH
NOTICE
www.holzmann-maschinen.at
ATTENTION
14.1 Maintenance
plan
35
D 460FXL