Fein Slugger JMU 137 QW Instrucciones De Uso página 23

OBJ_BUCH-0000000261-003.book Page 23 Thursday, April 27, 2017 7:47 AM
en
23
Starting and stopping the drill motor
Fig. 14
(figure 14).
To start the drill motor with clockwise rota-
tion, press the button with the „ " symbol.
The drill motor starts with the highest speed.
The last set speed is automatically stored
(Memory Function). To start the power tool
100 %
with the last set speed, press and hold the l
85 %
l
75 %
l
60 %
button with the symbol, and then press
l
50 %
l
the button with the symbol.
25 %
l
To lower the speed, press the „ " symbol.
To increase the speed, press the „ " sym-
bol.
To stop the drill motor, press the „ "
100 %
l
85 %
symbol.
l
75 %
l
60 %
l
50 %
Do not stop the drill motor during the drilling
l
25 %
procedure.
l
To start the drill motor with counterclock-
wise rotation, press the button with the
„ " symbol. The drill motor will run as
long as the button is pressed.
When the power supply is disconnected
Memory Function
while the drill motor is running, a protective
circuit prevents automatic restarting of the
drill motor. Restart the drill motor again.
In case of overload, the drill motor automati-
cally stops and must be restarted again.