Fein Slugger JMU 137 QW Instrucciones De Uso página 25

OBJ_BUCH-0000000261-003.book Page 25 Thursday, April 27, 2017 7:47 AM
Instructions for core drilling.
Only remove the cutting tool from the hole
while the motor is running.
If the carbide tipped cutter should remain
stuck in the material, stop the drill motor and
carefully turn the carbide tipped cutter out
clockwise.
After each drilling operation, remove the
chips and the slug.
Do not touch the chips with your bare
hand. Always use a chip hook.
Error message/
Response of magnet
button
Indicator lights up
green
Indicator flashes
green
Indicator lights up red
for 1 second
Indicator flashes red
3 x
Indicator lights up red
continuously
Indicator flashes red
continuously
Meaning
Magnetic holding power is
sufficient.
Magnetic holding power
possibly insufficient.
– Motion sensor has actuated
– Overload shut-off has
actuated
– Incorrect mains voltage
No speed signal
– Incorrect mains voltage/
mains frequency
– Drill stand is overheated
– Button is blocked when
switching on
Power tool is defective.
Danger of burns! The surface
CAUTION
of the magnet can reach high
temperatures. Do not touch the magnet with
your bare hands.
For core drilling in layered material, use a suit-
able Slugger ID cutter.
When changing a cutting tool, pay attention
not to damage the cutting edges.
When core drilling layered material, remove
the core and the chips after having drilled
through each layer.
Corrective action
Even when working on steel materi-
als where the material thickness is
below 12 mm, the workpiece must
be made thicker with an additional
steel plate in order to ensure the
magnetic holding power.
After malfunction correction, the
power tool can be switched on again.
If the error occurs frequently, send
the machine to your Slugger cus-
tomer service agent.
After malfunction correction, the
power tool can be switched on again.
If the error occurs frequently, send
the machine to your Slugger cus-
tomer service agent.
Send the machine to your Slugger
customer service agent
en
25