Brushes Disassembly; Squeegee Cleaning; Weekly Maintenance; Rear Squeegee Rubber Check - Tornado 99732 Manual De Operaciones Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BRUSHES DISASSEMBLY

The machines which have the
electrical brushes base lifting:
1. Switch on the machine by
turning the key (9) clockwise.
2. Press the push button (7) of
up/down brushes base to lift the
brushes.
3. Take off the electric supply by
turning the key (9) counterclock-
wise.
ATTENTION:
With the brushes base in lifted
position, turn the brush in its ro-
tating sense as indicated in the
figure, until it is released from
the brush holder plate seat. The
figure shows the rotating sense
for brushes release.
ATTENTION:

SQUEEGEE CLEANING

Keeping the squeegee clean
guarantees always the best dry-
ing action.
For its cleaning it is necessary
to:
1. Take off the squeegee hose
(5) from the coupling.
2. Disassemble the squeegee
(2) from its support (1) by rotat-
ing the lever (4) counterclock-
wise and making slide the stud
bolts (3) in their slots up to their
release.
3. Clean with care the internal
part of the squeegee inlet elimi-
nating eventual dirt residuals.
4. Clean with care the squeegee
rubbers.
5. Reassemble all parts.

WEEKLY MAINTENANCE

REAR SQUEEGEE RUBBER
CHECK
Check the squeegee rubber
wear and eventually turn or
replace it.
For the replacement it is neces-
sary to:
1. Lift the squeegee acting upon
the lever (17).
2. Release the hook (9) of the
rubber holder blade and take
the rubber off.
3. Turn the rubber to a new side
or replace it.
To reassemble the squeegee
repeat reverse the operations
above mentioned, inserting the
rubber on the guides and block-
ing it with the rubber holder
blade.
18

SQUEEGEE HOSE CLEANING

Weekly or in case of insufficient
suction, it is necessary to check
that the squeegee hose is not
obstructed. Eventually, to clean
it, proceed as follows:
1. Take off the hose (1) from the
squeegee coupling.
2. Wash the inside of the hose
with a water jet.
To reassemble the hose repeat
reverse the operations above.
ATTENTION:
CLEANING OF THE SOLU-
TION TANK
1. Bring the machine to an ap-
propriate place for the detergent
solution draining.
2. Unscrew the solution tank
cap.
3. Unscrew the cap of the
exhaust filter (1) so that the
detergent solution flows out into
appropriate containers. Pay at-
tention not to lose the gasket of
the cap.
4. Rinse with a water jet the
solution tank.
5. Reassemble all parts.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

99732 bd 3299732 bd 26

Tabla de contenido