Adjustment Of The Squeegee; Splash Guard Assembly; Brushes Assembly - Tornado 99732 Manual De Operaciones Y Mantenimiento

ADJUSTMENT OF THE
SQUEEGEE
In order to have a perfect drying
result through the squeegee,
the rear rubber must have the
lower bending uniformly ad-
justed in all its length. For the
adjustment, it is necessary to
put oneself in working condition
and therefore the suction motor
has to be switched on and the
brushes have to function to-
gether with the detergent solu-
tion.
The lower part of the rubber is
too much bent
Take off the pressure rotating
the wing nut (6) counterclock-
wise.
The lower part of the rubber is
not much bent
Increase the pressure rotating
the wing nut (6) clockwise.
The bending is not uniform
Adjust the squeegee inclina-
tion rotating counter-clockwise
the wing nut (7) to increase the
bending in the central part, or
clockwise to increase the bend-
ing on the extremities.
Height adjustment
Once that the pressure and
inclination of the squeegee has
been adjusted, it is necessary to
fix this optimum condition mak-
ing touch slightly the wheels
onto the floor. Rotate counter-
clockwise the registers (8) to
lower the wheels or clockwise
to raise them. Both wheels must
be adjusted in the same mea-
sure.
ATTENTION:
Every type of floor requires a
specific adjustment. For exam-
ple, concrete floors (where the
friction results to be high) need
little pressure, while smooth
floors (ceramics) need higher
pressure.
If the cleaning operations are
made always on the same type
of floor, the adjustment can
change only in function of the
rubber wear.

SPLASH GUARD ASSEMBLY

The two splash guards have to
be assembled onto the brushes
base group. Insert the metal
strips inside the suitable slots
present on the rubber. Place the
round hole at the flat extremity
of the strip onto the screw (1)
placed in the front part of the
brushes base group. Secure the
strips through the nut blocking
it.
13
Block the coupling levers (2)
in the rear part of the brushes
base group to the rings placed
at the extremity of the metal
strips still free. Please act as
above for both splash guard
rubbers, paying attention to
reduce to the minimum the gap
between the two rubbers in the
front part of the brushes base
group.
With brushes assembled, the
splash guard must slightly touch
the floor.

BRUSHES ASSEMBLY

The machines which have the
electrical brushes base lifting:
1. Switch on the machine by
turning the key (9) clockwise.
2. Press the push button (7) of
up/down brushes base to lift the
brushes.
3. Take off the electric supply by
turning the key (9) counterclock-
wise.
ATTENTION:
To carry out brushes assembly
operations with the electric sup-
ply on, may cause damages to
hands.