The Squeegee Does Not Dry Perfectly; Excessive Foam Production; Programmed Maintenance - Tornado 99732 Manual De Operaciones Y Mantenimiento

3. The detergent solution is
insufficient: open more the solu-
tion valve.
4. Check that the liquid deter-
gent is in the recommended
percentage.
5. Increase the brushes base
pressure (see at paragraph
"ADJUSTMENT OF THE
BRUSHES PRESSURE").
Contact the authorized technical
assistance for advice.
THE SQUEEGEE DOES NOT
DRY PERFECTLY
1. Check that the squeegee rub-
bers are clean.

PROGRAMMED MAINTENANCE

INTERVENTION
RECOVERY TANK CLEANING
SUCTION FILTER CLEANING
SOLUTION TANK FILTER CLEANING
BRUSHES CLEANING
BRUSHES DISASSEMBLY AND CLEANING
SQUEEGEE CLEANING
FRONT SQUEEGEE RUBBER REPLACEMENT
REAR SQUEEGEE RUBBER REPLACEMENT
SPLASH GUARD RUBBER REPLACEMENT
CHECK SQUEEGEE ADJUSTMENT
SQUEEGEE HOSE CLEANING
SOLUTION TANK CLEANING
CHECK BATTERIES ELECTROLYTE
CHECK OF THE BRAKE
TRACTION MOTOR CHECK
BRUSHES MOTOR CHECK
SUCTION MOTOR CHECK
CHECK BRUSHES BASE GROUP
SCREW TIGHTENING
* The hours refer to the ones indicated on the display (see under paragraph "HOUR METER").
2. Check the adjustment of the
height and the inclination of the
squeegee (see section "AD-
JUSTMENT OF THE SQUEE-
GEE" in "BEFORE USE").
3. Check that the suction hose
is correctly inserted in the prop-
er seat on the recovery tank.
4. Clean the suction filter.
5. Replace the rubbers if worn
out.
6. Check that the suction motor
switch is on.
DAILY
21
EXCESSIVE FOAM PRODUC-
TION
Check that low foam detergent
has been used. Eventually add
small quantities of anti foam
liquid into the recovery tank.
Please be aware that a bigger
quantity of foam is produced
when the floor is not very dirty.
In this case please dilute deter-
gent solution.
20 HOURS *
•
•
•
•
•
•
•
•
•
•
•
200 HOURS * 1000 HOURS *
•
•
•
•
•
•
•
•