JVC TK-C676 Instrucciones página 17

Ceiling Mount
Camera
Camera clamping bracket
Rotate the camera
clockwise.
Lock screw
Tighten the lock screw.
Lock screw
Camera clamping
bracket
2.
Ensure that the lock screw is loose.
The camera cannot be attached properly if the lock screw
of the Ceiling Mount is too tight.
3.
Fit the camera.
Check the position of the camera clamping bracket and
that of the lock screw, and fit the camera onto the ceiling
mount.
4.
Rotate the camera.
Make sure that the camera is horizontal, then turn the
camera clockwise until it stops. Ensure that the camera-
clamping bracket is in line with the lock screw of the Ceil-
ing Mount.
5.
Tighten the lock screw.
Tighten the lock screw using a Phillips screwdriver.
CAUTION
If the lock screw is not tightened firmly, the camera may rattle or
fall down. Be sure to tighten the lock screw firmly.
* To remove of the camera from the ceiling
mount, reverse the steps
1 5
to .
E-17