Connections & Installation A Multi-Drop Communication System - JVC TK-C676 Instrucciones

Ocultar thumbs Ver también para TK-C676:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Connections & Installation
A Multi-Drop Communication System
A system that employs the RM-P2580 as the controller
The following figure shows a system that can accommodate up to eight cameras. (64 positions can be preset per camera.)
TK-C676
Camera 1
MACHINE ID: 01
Switch 8: OFF
(RX TERM)
TK-C676
Camera 2
MACHINE ID: 02
Switch 8: OFF
(RX TERM)
TK-C676
Camera 8
MACHINE ID: 08
Switch 8: ON
(RX TERM)
Remote control unit
Cable connections
(Terminal side of Ceiling Mount)
Control signal cable
Coaxial cable
Power cable
Connection of the control signal cable
(A twisted pair cable is recommended.)
RM-P2580
Camera 1
CONTROL terminals
terminal
TX + A
RX +
A
TX – B
RX –
B
RX + C
TX +
C
RX – D
TX –
D
Camera 2
CONTROL
terminals
TX +
A
Each terminal on the camera and the RM-
TX – B
RX + C
P2580 is marked
RX – D
to facilitate understanding and to avoid
Camera 3
connection mistakes, it is recommended
CONTROL
terminals
to connect the terminals carrying the
TX + A
same marks.
TX – B
RX + C
RX – D
E-8
Control signal cable
Coaxial cable
AC 24 V
power supply
AC 24 V
power supply
AC 24 V
power supply
TO
CAMERA
RM-P2580
P. 14
To the TO CAMERA connector of the
RM-P2580 and to the next camera
To the CAMERA INPUT connector
of the RM-P2580
To AC 24V power supply
,
,
or
. In order
A
B
C
D
Observe the following points when connecting compo-
nents together:
• Turn all the components off before proceeding.
• Read the instruction manuals of all components before pro-
ceeding.
• For the types and lengths of connection cables, see "Cable
Connections" on page 14.
• Do not connect the control signal cables in a loop.
MONITOR
OUTPUT 1
Switch settings
(Setting switches are on the side of the Ceiling Mount)
Machine ID
Figure of 1
Figure of 10
Set it to the same number as the
VIDEO INPUT terminal of the RM-
P2580.
(Example) Camera 1:
Set the figure of 10 to "0" and
figure of 1 to "1".
Camera 1 monitor display
at power ON
>> I I
N T I A
L PROCESS<<
PAN
: - - I - -
T I LT
: - - I - -
>P
ROT
O OL
C
DUPLEX I D - 01
Duplex display
ID No. display
(ID check procedure
P. 13)
Monitor
P. 12
Switch 1 :
Invalid (Set to OFF.)
Switch 2 :
Switch 4 : ON
Switch 5 : OFF
Switch 7 : Invalid (Set to OFF.)
Switch 8 :
Set to ON only for the
camera connected at
the end of the control
signal cable.
Set to OFF for all
other cameras.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido