Assembly; Head Suspension Installation - 3M Whitecap W-8100B-CA Instrucciones De Uso

ASSEmBLy

Head Suspension Installation

before installing the head suspension into the helmet, you will need to adjust the head size, height
adjustment, and faceshield distance (fig. 4).
Head size
Height adjustment
Faceshield distance
Head Size Adjustment
1. Hold the suspension system in front of you so you face the size adjustment buttons (fig. 5).
2. disengage the size adjustment buttons.
3. Slide the headband in or out to the desired size and push the size adjustment buttons in the proper
holes.
4. Put the suspension on your head to check the fit. Readjust if necessary.
Suspension into Helmet Installation
1. Place helmet shell upside down in your lap.
2. Make sure the headband size adjustment is at the rear of the helmet shell. Securely seat the
suspension lugs in the inner shell pockets (fig. 6).
3. try the helmet on and check the fit. Adjust suspension for height or balance, if necessary.
Adjust the headband to fit hat sizes from 6
Raise or lower the helmet on your head.
Set the distance of the faceshield from your face.
fig. 5
/
1
fig. 4
12
to 8.
2
fig. 6