Faceshield Assembly - 3M Whitecap W-8100B-CA Instrucciones De Uso

Shroud Clamp
the shroud clamp is designed to secure both inner and outer shrouds to the helmet. this consists of a
stainless steel band and quick release clamp to assist in shroud installation and removal.
Outer Shroud
1. feed the open end of the shroud band into the slit on the right of the shroud collar.
2. thread the band of the shroud through the collar and out the other opening.
3. Lift the screw clamp up and insert the belt into the slot below the screw. Insert excess band into the
shroud slit (fig. 8).
4. Position the seam of the outer shroud to match up with the seam on the inner shroud and then
place the shroud over the inner shroud in the groove at the bottom of the helmet.
5. Lift up on the screw clamp and push the band against the shroud to take up the excess. Push the
screw clamp down and slide the band over the slit on the right.
6. tighten the screw clamp using a screwdriver.
Shroud Clamp Quick release
to release the shroud clamp, simply loosen the screw one to two turns and then push the screw clamp
up to free the band. the shrouds can then be removed for cleaning or replacement.
Replace the inner or outer shroud if it is worn or damaged. Replace the shroud clamp if it will no
longer secure the shrouds to the helmet.

Faceshield Assembly

the abrasive blasting faceshield screens, faceshield covers and the outer faceshield are all installed
inside the faceshield frame for the 3M™ Whitecap™ Abrasive blasting Helmet (fig. 9).
fig. 8
faceshield Screen
faceshield frame
14
outer faceshield
faceshield Covers
fig. 9