End Of Product Life; Troubleshooting - Sunoptic Surgical Titan x450 Manual De Usuario

Ocultar thumbs Ver también para Titan x450:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

8.2 LIMITED WARRANTY
Your illumination product(s) carry(s) a 3-year warranty from the date of shipment on
workmanship and all defects of material, excluding, fiberoptic cable and lamps. Should your
product prove to have such defects within three years of the shipment, Sunoptic Surgical
repair or replace the product or component part without charge.
product(s) need servicing under this warranty, please contact Sunoptic Surgical
authorization documentation.Please carefully pack the unit in a sturdy carton and ship it to the
factory. Include a note describing the defects, your name, telephone number and a return
address. Warranty does not cover equipment subject to misuse, accidental damage, normal
wear and tear or if transferred to a new owner without authorization from Sunoptic Surgical
This warranty gives you specific legal rights and you may also have other rights that vary from
state to state.
POST WARRANTY REPAIRS: You may return your product(s) for repair, shipping prepaid to
the factory. Your product will be inspected and an estimate of repair charges will be submitted
to you for approval.
In the US call:
FAX number:
9.

END OF PRODUCT LIFE

In accordance with the European Waste from Electrical and Electronic Equipment (WEEE)
directive, we encourage our customers to recycle this product whenever possible. Disposal of
this unit must be performed in accordance with the applicable local environmental regulations.
In the US a list of recyclers in your area can be found at: http:/www.eiae.org/.
Please contact customer service to issue a return authorization to return product to
manufacturer at the end of product life.
10.

TROUBLESHOOTING

Problem
Power indicator (refer to
4.2) is not lit.
Power indicator is lit, but
Xenon lamp will not ignite.
LIT-219 SUNOPTIC SURGICAL
(English)
877 677-2832
904 733-4832
Solution
Check that the AC power cord is properly connected.
Check power input switch position.
Check the circuit breakers. If necessary, reset.
If any inoperable fault condition is displayed on the screen,
correct the condition shown per section 6.2.1.
®
Should your illumination
®
for return
(toll free)
Rev. -
Date of Revision: 06/21/16
Page 19 of 104
®
will
®
.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Tx450d

Tabla de contenido