Warranty; End Of Product Life - Sunoptic Surgical Titan X300 Manual Del Operador

Ocultar thumbs Ver también para Titan X300:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 59
Move the lamp positioning lever (found to the right of the lamp) clockwise, from horizontal to
vertical, and pull the lamp cartridge out.
Grasp only the horizontal top and bottom grip flanges of the plastic housing of the lamp, pull
straight out to remove the lamp. Insert a new one (lamp pointed to the left), pushing firmly
to assure full engagement to the power connectors. Lower the lamp engagement lever
counter-clockwise, from vertical to horizontal, and observe that the lamp rises about 3mm as
it moves to its proper operating position.
Log the serial number and hours on the hour meter. Close the lamp compartment door.
Re-connect the power cord and turn the light source on according to 6.1. Reset hour meter
to zero by depressing hour meter reset button on rear panel.
NOTE
If the tamper seal on the lightsource is broken, the WARRANTY WILL BE
VOIDED. There are no other user serviceable parts in the unit.
8.2 LIMITED WARRANTY
Your illumination product(s) carry(s) a 3-year warranty from the date of shipment on
workmanship and all defects of material, excluding, fiberoptic cable and lamps. Should your
product prove to have such defects within three years of the shipment, SUNOPTIC
®
TECHNOLOGIES
Should your illumination product(s) need servicing under this warranty, please contact
SUNOPTIC TECHNOLOGIES
pack the unit in a sturdy carton and ship it to the factory. Include a note describing the
defects, your name, telephone number and a return address. Warranty does not cover
equipment subject to misuse, accidental damage, normal wear and tear or if transferred to
a new owner without authorization from SUNOPTIC TECHNOLOGIES
gives you specific legal rights and you may also have other rights that vary from state to
state.
POST WARRANTY REPAIRS: You may return your product(s) for repair, shipping prepaid
to the factory. Your product will be inspected and an estimate of repair charges will be
submitted to you for approval.
In the US call:
FAX number:
Customer Service
9.

END OF PRODUCT LIFE

In accordance with the European Waste from Electrical and Electronic Equipment (WEEE)
directive, we encourage our customers to recycle this product whenever possible. Disposal
of this unit must be performed in accordance with the applicable local environmental
regulations.
In the US a list of recyclers in your area can be found at: http:/www.eiae.org/.
Please contact customer service to issue a return authorization to return product to
manufacturer at the end of product life.
LIT-217 Sunoptic Surgical
Rev. D
will repair or replace the product or component part without charge.
®
for return authorization documentation. Please carefully
®
Page 12 of 112
877 677-2832
(toll free)
904 733-4832
904-737-7611
®
. This warranty
(English)

Publicidad

Tabla de contenido
loading

Tabla de contenido