Attaching Labels - Brother P-touch 1300 Manual Del Usaurio

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Industrial (super-adhesive) tape
Compared to conventional laminated tape, industrial tape has a greater adhesive
strength, providing better adhesion to difficult surfaces. Due to this improved adhe-
sion, follow the precautions below when using this tape.
Do not attach this tape to skin.
Depending on the environmental conditions of the location and the quality of the
material that this tape is attached to, the tape may become discolored or it may
become impossible to remove it completely, possibly damaging the surface that it
was affixed to.
Before using this tape, test it by affixing a small piece to an unnoticeable area of
the intended surface.
If adhesive accumulated on the tape cutter makes it difficult to cut the tape, clean
the tape cutter as explained on page 12.
LAMINATED TAPE
The enclosed tape separator enables you to easily remove the backing from labels
printed on laminated tapes.
1
Hold the tape in your left hand, with the printed surface facing up, and hold the
tape separator in your right hand.
2
Pass the tape halfway through the long narrow hole in the tape separator.
3
Turn the tape separator three-quarters of a turn towards you, and then pull the
tape separator away from you as shown below.
4
Peel off the label backing.
8

ATTACHING LABELS

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido