Brother P-touch 1300 Manual Del Usaurio página 71

Error
Message
LINE
LIMIT!
MEMORY
FULL!
NEED A, B, C, D
START&END
NO
FILES!
NO
TAPE!
NUMBER
TOO SMALL!
REPLACE
BATTERIES!
Cause
• This message appears if
the number of lines in the
text is greater than the
maximum number of lines
possible for the installed
tape.
• This message appears if
you try to store a text file
after 300 characters have
already been stored in the
memory.
• This message appears if a
letter between A and D
has not been entered at the
beginning and end of the
barcode data when the
CODABAR protocol is
used.
• This message appears if
you try to recall or delete a
text file from the memory
when none are stored.
• This message appears if
you try to print a label or
feed the tape when a tape
cassette is not installed.
• This message appears if
the last number set to be
printed is less than the
selected number in the
text when using the num-
bering function.
• This message appears if
the installed alkaline bat-
teries are about to run out.
Remedy
• Reduce the number of
lines or install a tape of
greater width.
• Delete an unwanted file to
make room for the new
one.
• Enter a letter between A
and D at the beginning
and end of the barcode
data.
• Store a text file first.
• Install a tape cassette and
try again.
• Press the key of a number
that is greater than the
number in the text.
• Replace the batteries or
use the AC adapter.
67