Operation Programs - ECOFOREST ecoSMART e-system Manual Instalador

EMERGENCY status due to active alarm
The controller is in a state of emergency because of an active alarm. The
controller still run but the alarm warns us of abnormal behavior and
registers it.

5.4. Operation programs

The operating modes active in the ecoSMART e-system are reflected in the main screen
and give a quick reading of the behavior of the control at any time.
SURPLUS CONTROL Mode
The control will regulate the consumption of the heat pump if the
comfort conditions are fulfilled to take advantage of the electric surplus.
CONSUMPTION CONTROL Mode
The control will regulate the consumption of the heat pump to adjust
the total consumption of the installation to the maximum limit set by
the installer.
TARIFF CONTROL Mode
We can set up schedules for peak or valley tariff periods, both in winter
and summer, so that, depending on the service covered by the heat
pump, we can reduce consumption in the hours where electricity is more
expensive and take advantage of periods where electricity is cheaper,
this means a great saving in your annual bill. There are four possible
states for tariff control.
-Tariff 1: Peak period in winter months.
-Tariff 2: Valley period in winter months.
-Tariff 3: Peak period in summer months.
-Tariff 4: Valley period in summer months.
User manual ecoSMART e-system
72