List Of User Menu - ECOFOREST ecoSMART e-system Manual Instalador

REGULATION signal
There is an active output to regulate the speed of the compressor in the
heat pump.
SETPOINT MODIFICATION signal
There is a setpoint change output on the heat pump.
NON CRITICAL LOAD ACTIVE signal
Relay output to non-critical load enabled (up to four loads).

5.6. List of user menu

Follow the instructions below to browse through the various user menus. Each menu
has a series of screens that are used to change heat pump STATUS and OPERATION
MODE, adjust comfort parameters and view desired information.
To access to the installer menu, you need to enter a 4-digit code. Simultaneously press
the key and to enter your installer password.
User manual ecoSMART e-system
74