Communications Menú; Surplus Control Menú - ECOFOREST ecoSMART e-system Manual Instalador

5.12. COMMUNICATIONS menu
1425 ta mu 2/6 Sytm
a.Chag aguag c.Pow maumt
b.Sytm .No-cctca oa
c.Svc .Commucato
5/5 Fbu1 cofg.

Bauat
Stop bt
Paty mo
BMS2 cofguato

Bauat
Stop bt
Paty mo
pN cofguato

Bauat
TWO
5.13. SURPLUS CONTROL menu
ta mu 3/6 3/6 Svc
b.Sytm a.Supu coto
c.Svc b.Coumpto coto
.Maua tt c.Taff coto
1/4 ctvato/actvato
ctvato
tvato tm
Dactvato
Dactvato tm
Supu tpot
0.5kW
25
DHW
Hatg
Coog
Poo
5/5
Fieldbus1 configuration
16
9600
It allows us to modify the configuration parameters of the master port
ONE
NO
Fieldbus1 (device address on the network, baudrate, number of stop
bits and parity).
BMS2 configuration
16
9600
It allows us to modify the configuration parameters of the slave port
TWO
NO
BMS2 (device address on the network, baudrate, number of stop bits
and parity).
pLAN configuration
16
62500
It allows us to modify the address and baudrate of the communication
port pLAN.
1/4
Activation/deactivation
0.5kW
25
This screen allows us to set the limits for the activation and
-1.5kW
deactivation of the heat pump regulation by surplus. It is necessary to
25
configure a power injection limit and a time for the activation as well
as a consumption limit and a time for the deactivation of the
regulation.
Surplus setpoints
StT
Show the maximum configurable target setpoints that the heat pump
65.0C
55.0C
will try to reach in each active service in case of surplus. The greater
7.0C
55.0C
the value of the surplus setpoint in the service, the more thermal
energy we will be able to accumulate.
User manual ecoSMART e-system
78