Consumption Control Menú; Tariff Control Menú - ECOFOREST ecoSMART e-system Manual Instalador

Supu guato
Baac
55.0C
7.0C
55.0C
5.14. CONSUMPTION CONTROL menu
ta mu 3/6 Svc
b.Sytm a.Supu coto
c.Svc b.Coumpto coto
.Maua tt c.Taff coto
2/4 Ma. coumpto g.
Coumpto mt -3.0kW
5.15. TARIFF CONTROL menu
Svco
ta mu 3/6
b.Coto  coumo
b.Sytm
c.Svc c.Coto  tafa
.Maua tt .Moo SG
Wt pak taff
Day MONDY
Copy to 
1 0000 OFF
2 0800 ON
3 1000 OFF
4 2000 ON
Wt taff Tmp
Pak ay
DHW -2
Hatg -2
Coog 2
Poo -2
Surplus regulation
The balance for the surplus regulation set by default is zero. This means
0.0kW
that when your
e-system is regulating the surplus, it will try at any time to reach a zero
value of balance with the grid (zero consumption and zero injection).
Since the electrical output and consumption of the heat pump vary
over time, there may be small fluctuations in this value. It is possible to
change the value of the balance according to the desired consumption
modulation of the heat pump.
*Positive power values refer to positive flows of energy to the grid (injection
power values refer to negative flows of energy from the grid (consumption).
2/4
Maximum consumption regulation
Configuration of the maximum consumption value of the electrical
installation for which the heat pump will regulate his consumption.
3/4
Peak/valley and winter/summer schedule tariff
NO
We can configure up to four-time zones in four calendars to define the
peak and valley periods of electric billing in winter (from December 21
to June 21) and summer (from June 21 to December 21).
Temperature differential for winter tariff
We define the temperature differentials on the pump setpoint in the
2 C
2 C
peak and valley periods for each service in winter period.
-2 C
2 C
Installer manual ecoSMART e-system
79
).
Negative