Accumulator Hazard; Hydraulic Oil And Lubrication Hazards - Atlas Copco LH 11 Instrucciones De Seguridad Y De Funcionamiento

LH 11, 18, 19 E, 22, 23 E, 27, 28 E, 39, 40 E
Warning
An incorrect dimension of the working tool's shank
can result in the working tool being lost or slipping
out during operation. A working tool that is lost or
slips out can cause personal injury.
► Before inserting the work tool, make sure that
the shank's dimensions are correct for use in the
machine.
► Working tools without a collar may not be used.
Warning
If the tool retainer on the machine is not in a locked
position, the tool can be ejected with force, which
can cause personal injury.
► Once the working tool has been mounted and
locked, the locking function must be checked by
pulling the working tool outwards forcefully.
► Make sure that the tool is fully inserted and the
tool retainer is in the locked position before the
machine is started.
► Never point the working tool at yourself or
anyone else.
Warning
Starting the machine while changing the working
tool may cause personal injury.
► Before changing the tool, stop the machine,
switch off the hydraulic oil supply and bleed the
machine by activating the start and stop device.
Warning
A hydraulic hose that comes loose can lash around
and cause personal injury or death. To reduce
risks:
► Check that the hydraulic hose and the
connections are not damaged.
► Check that all hydraulic connections are properly
attached.
► Never attempt to disconnect a hydraulic hose
that is pressurized. First switch off the hydraulic
oil flow by the power pack and then bleed the
machine by activating the start and stop device.
© 2007 Atlas Copco Construction Tools AB
www.CrowderSupply.com • Toll Free: 888-883-5144
| |
No. 3392 5010 83 f 2007-03-06
Safety and operating instructions

Accumulator hazard

Danger
The machine has a pressure accumulator. The
pressure accumulator may only be charged with
nitrogen gas (N ).
2
► Only authorized personnel are qualified to work
with the accumulator.
► Do not perform any work on the machine, the
connections or any hoses, when the hydraulic
system is pressurized.
Note! If the maximum working pressure for the
machine is exceeded, the accumulator can
be overcharged, which can result in material
damage.
► Always run the machine with the correct working
pressure. See "Technical data".
Hydraulic oil and lubrication
hazards
Warning
Thin jets of hydraulic oil under high pressure can
penetrate the skin and cause permanent damage.
► Never use your hands when searching for oil leaks.
► Keep your face away from any possible leaks.
► Immediately seek medical attention if hydraulic
oil has penetrated the skin.
Warning
Spilled hydraulic oil can cause accidents by
causing slippery conditions and will also harm the
environment.
► Handle the hydraulic oil with care.
► Take care of all spilled oil and handle it
according to your local safety and environmental
regulations.
Caution
Hot hydraulic oil can cause burns.
► Never dismount the machine when the hydraulic
oil is hot.
Caution
Hydraulic oil can cause eczema when it comes in
contact with the skin.
► Avoid getting hydraulic oil on your hands.
► Always use protective gloves when working with
hydraulic oil.
7