Össur Cheetah Xtreme Instrucciones Para El Uso página 6

ENGLISH
CHEEtaH XtrEmE & CHEEtaH
®
Cheetah System
• Custom foot model for sprinting and recreational running.
• Maximum build height
– Cheetah Xtreme 530mm (20 14/16")
– Cheetah Xtend 451mm (17 ¾")
• Minimum build height
– Cheetah Xtreme 375mm (14 ¾")
– Cheetah Xtend 330mm (13")
• Maximum weight 147 kg (325lbs)
• One foot size
LamINatIoN CoNNECtor (Figure a)
FSX50002 (1-9)
• Lamination connector is laminated directly into the posterior socket
wall.
• Placement of the lamination connector is recommended in the middle
1/3 of the socket for easier height adjustment.
• Make sure the socket surface is flat over the lamination connector to
ensure good load distribution on the foot module when connected.
Bolts go through blade into lamination connector in socket. Apply Loctite
410 to all threads and torque to following specifications:
Category
1-9
the Cheetah
®
direct lamination.
FrICtIoN PadS
Always use friction pads between foot module and socket.
aLIGNmENt adaPtEr (Figure B&C)
important: Only use alignment adapter for dynamic alignment
adjustments.
• Determine adapter to socket position according to athlete height
requirements.
• Attach alignment adapter to check socket using epoxy or bonding
compound.
• Reinforce attachment using Tech Form Cast tape.
• Use adjustment screws to adjust foot contact point following
alignment recommendations:
– Figure B
1. Inversion/eversion foot adjustment
2. Height adjustment
– Figure C
1. Dorsi/plantar flexion adjustment screw
2. Internal/external rotation adjustment screw
BENCH aLIGNmENt
Sagital plane (Figure d)
• Determine vertical socket position in alignment jig.
• Load line bisects socket and falls through the ground contact point or
approximately 63mm (2.5") posterior to end of toe.
• Clamp foot into a 7° flexion position.
5
Bolt Size
3/8"
Xtreme and Cheetah
XtENd
®
torque
45 Nm ( 33 ft-lbs )
Xtend may also be connected by
®