Uninstallation Of The Associated Sensor(S); Prohibited Uses; Maintenance And Periodic Check; Recharging The Battery - Tractel dynafor HHD Manual De Instalación, De Utilización Y De Mantenimiento

Pantalla de mano electrónica
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 73
NB: Turning off the product does not cause the
sensor to switch off.
GB
5.7. Uninstallation of the associated
sensor(s).
When deinstalling the sensors, make sure that all
tensile forces have been removed beforehand.
Clean the product and store it according to the chapters
7.2. Autres vérifications and 8.Transport et stockage

6. Prohibited uses

THE FOLLOWING ARE FORBIDDEN:
• Modifying the product.
• Exposing the product to any electric and/or
electromagnetic shock.
• Disassembling or opening the product.
• Using the product for operations other than those
described in this manual.
• Using the product in a highly corrosive environment.
• Using the product in an explosive environment.
• Using the product outside the temperature range of
-20°C to 50°C.
• Using the product if it does not appear to be in good
condition.
• Using the product if the markings are missing or
illegible.
• Using the product with sensors and accessories other
than those specified by Tractel
See also the prohibited uses in the manuals associated
with the sensors and other accessories.

7. Maintenance and periodic check

7.1. Recharging the battery

A warning message is displayed on the hand held
device. Proceed to recharge the battery:
• Either using the charger and its cable supplied with
the product;
• Or with a power device with USB type A (PC, external
battery), using the USB C to A cable supplied with the
product.
IMPORTANT: The battery can only be replaced
by Tractel
or an authorised repairer in the event of a
®
malfunction.
Characteristics of the battery: Lithium battery, brand
ENIX, LP906090 6,000 mAh 3.7 V
18
in this manual.
®

7.2. Other checks

Tractel
recommends periodically inspecting the visual
®
condition of the product and cleaning the product
regularly with a dry cloth.

8. Transport and storage

During storage and/or transport, the product must be:
• Placed in its original packaging or in the designated
position of the sensor case.
• Stored in a dry location.
• Stored at a temperature between -20°C and 60°C.
• Protected from chemical, mechanical or any other
type of attack.
9. Product disposal and environmental
protection
The product must be disposed of in accordance with the
regulations applicable in the country of use.
The product complies with the requirements of the
REACH regulation and the RoHS directive; it is not
covered by the WEEE directive.
The different product components must be recycled on
the basis of the table below, after separating metal and
synthetic materials. These materials must be recycled
by specialised organisations.
At the time of disposal, only trained individuals may
dismantle the product to separate its components.
Component
Housing (plastic)
Printed circuit board and
display unit
Battery
To be treated as a waste
of the type
Ordinary waste
Electronics
Accumulator

Publicidad

Tabla de contenido
loading

Tabla de contenido