Leister GEOSTAR G5 Instrucciones De Servicio página 33

Setting the Date and Time for Welding Data Recording
• In the function display (33), rotate the "e-Drive"
• Press "e-Drive"
briefly.
• Select "Welding Data Record." in the "Setup" menu by rotating the "e-Drive"
• Rotate the "e-Drive"
• To set the hours by rotating the "e-Drive"
Rotate the "e-Drive"
• To set the minute, year, month, and day by rotating the "e-Drive"
press "e-Drive" briefly.
Rotate the "e-Drive"
• In the function display (33), rotate the "e-Drive"
The applied settings are saved by the device.
Setting the Parameters for Welding Data Recording
• In the function display (33), rotate the "e-Drive"
• Press "e-Drive"
briefly.
• Select "Welding Data Record." in the "Setup" menu by rotating the "e-Drive"
Switching on data recording:
• Rotate the "e-Drive"
Rotate the "e-Drive"
Switching on the name affix for the welding seam (optionally, as required):
• Rotate the "e-Drive"
Rotate the "e-Drive"
Setting the welding seam name (optionally, as required):
• Rotate the "e-Drive"
The current name is displayed on the top line. "--" means that a name has not been defined.
Rotate the "e-Drive"
Enter the desired name (see Chap. "Entering Names or Passwords"), confirming this afterwards by selecting the
symbol and by pressing the "e-Drive"
to select "Date & Time" and press "e-Drive"
, select "Hour" and press "e-Drive"
to set the value and press "e-Drive"
to set the value and press "e-Drive"
to select "Data Recording" and press "e-Drive"
to select "I" and press "e-Drive"
to select "Seam Naming" and press "e-Drive"
to select "I" and press "e-Drive"
to select "Seam Name" and press "e-Drive"
to select "Seam Name" and press "e-Drive"
.
to select the Settings menu
briefly.
briefly.
, select the corresponding menu item and
briefly.
to select the symbol "Return to working display"
to select the Settings menu
briefly.
briefly.
briefly.
briefly.
briefly.
briefly.
.
and pressing it briefly.
briefly.
.
and pressing it briefly.
.
33