Leister GEOSTAR G5 Instrucciones De Servicio página 37

Data Synchronization
The welding data files recorded by the automatic welder are read by the "myLeister app" and synchronized. For this
to take place, the WLAN module of the automatic welder must be switched on.
Important: Data must regularly be synchronized with the "myLeister app". Otherwise, unsynchronized welding data
can be lost from the device; for example, if the operating unit is defective.
Switching on the WLAN module:
• In the function display (33), rotate the "e-Drive"
• Press "e-Drive" briefly.
• Select "WLAN Settings" in the "Setup" menu by rotating the "e-Drive"
• Rotate the "e-Drive"
Rotate the "e-Drive"
• In the function display (33), rotate the "e-Drive"
WLAN connection status display:
The data exchange between the automatic welder and the myLeister app starts from the
myLeister app.
The
ed to the "myLeister app".
Switching off the WLAN module:
• In the function display (33), rotate the "e-Drive"
• Press "e-Drive" briefly.
• Select "WLAN Settings" in the "Setup" menu by rotating the "e-Drive"
• Rotate the "e-Drive"
Rotate the "e-Drive"
• In the function display (33), rotate the "e-Drive"
to select "WLAN" and press "e-Drive"
to select "I" and press "e-Drive"
symbolis displayed in the status line (35) when the automatic welder is connect-
to select "WLAN" and press "e-Drive"
to select "0" and press "e-Drive"
to select the Settings menu
and pressing it briefly.
briefly.
briefly.
to select the symbol "Return to working display"
to select the Settings menu
and pressing it briefly.
briefly.
briefly.
to select the symbol "Return to working display"
.
.
.
.
37