Adjusting The Volume; Adjusting The Brightness - Teac NS-X1 El Manual Del Propietario

Adjusting the volume

Press the VOLUME – or + button on the unit or on the remote control
to adjust the volume.
The current volume level setting will be displayed for about 3
o
seconds.
The volume level setting can be adjusted from 0 to 50.
o
"MIN" represents volume 0 and "MAX" represents 50.
o
Muting the sound temporarily
Press the MUTE (°) button on the remote control.
The volume level setting on the display will blink when the mute
o
function is on. (Example: When the volume is set to 12.)
A u t o
8 7 .
To turn off the mute setting, press the MUTE(
o
press the VOLUME - or + button on the remote control or unit.
Note
You can turn the mute setting on only by using the remote control.
Selecting a preset EQ
Press the PRESET EQ button on the remote control to change the
current setting.
Each time you press the PRESET EQ button, the unit cycles through
o
the following settings: FLAT, ROCK, POP, CLASSIC, JAZZ and TALK.
1 2
5 0 M H z P 0 1
°) button again or

Adjusting the brightness

Press the DIMMER (¦) button on the remote control.
The brightness level setting will change as follows:
o
<Normal>
A u t o
8 8 .
<Dark>
A u t o
8 8 .
<Very dark>
A u t o
8 8 .
Checking the information
Press the DISPLAY button on the remote control to check the playback
information.
It is available only when Net Radio or MUSIC SERVER is selected as the
input source or AirPlay is activated.
N o w
B l a c
G . N A
The following information is shown on the third line of the display.
: Current state of the unit
: Current file name or ID3 information
: Elapsed playback time wFile typewAlbum title
wFile sizewArtist name
Each time you press the DISPLAY button, the display cycles through
o
the above information.
5 0 M H z P 0 1
5 0 M H z P 0 1
5 0 M H z P 0 1
P l a y i n g
k & W h i t e
13