Teac NS-X1 El Manual Del Propietario página 26

Clock
Setting the time zone
1
From the "Settings" menu, select "Clock" and then "Clock
GMT".
> C
l o c
C l o c
2
Press the UP or DOWN (5 or b) button to change the
time zone.
G M T :
Default setting is 00 (GMT).
o
You can select the time zone from -12 to +12.
o
3
Press the ENTER button when the setting is done.
Note
Be sure to change the time zone while the unit is connected to the
o
Internet.
GMT stands for Greenwich Mean Time. You should find out if your
o
local time zone is past or ahead of the Greenwich Mean Time and
then enter the time.
26
Settings (3)
k G M T
k A d j u s t
0
Setting the clock
Note
Because the unit updates the time through the Internet, it
o
needs to be connected to the network before you start setting
the time. To see detailed information on setting wired/wireless
network, see "Network Setup" on pages 23 to 25.
You can also set the clock by pressing and holding the CLOCK
o
(ADJ) button on the remote control for 2 seconds.
From the "Settings" menu, select " Clock " and then " Clock
Adjust " .
C l o c
> C
l o c
The unit will show the "Clock Adjust" message on the display
o
and adjust the time automatically according to the time zone.
C l o c k
Checking the time
After setting the time, you can check the time.
Simply press the CLOCK (ADJ) button on the remote control.
k G M T
k A d j u s t
A d j u s t