Install A Digital Extension Cable; Scan For New Devices - Hach PAH500 Manual Del Usuario

3.3 Install a digital extension cable

Use a digital extension cable to connect the digital gateway to an SC1000 Controller. Refer to
Figure 7. Refer to Replacement parts and accessories on page 29 for the cable lengths available.
Prevent kinks and tight bends in the cable. Install the supplied ferrites on the cable. The ferrite
locations on the cable are important. Refer to Figure 7.
Figure 7 Install a digital extension cable

3.4 Scan for new devices

If the controller does not recognize the sensor unit, select SC1000 SETUP > DEVICE
MANAGEMENT > SCANNING FOR NEW DEVICES or restart the controller.
English 13