SHERCO Enduro Manual Del Usuario página 50

1
3
2
6
Unscrew the engine oil filler cap . page 98, 2
Pour in approx. 1.3 litres of
Check the level of oil through window as explained on page 98.
Top up the level if necessary
!
Warning : To protect the environment, old oil and filters should be deposited
at a collection center.
100
- Replace the plug 1 and screw to 20 Nm
- Replace the pre-filter 3 and the plug 2 as
shown on photo.
- Tighten the plug to 35 Nm
-Fit a new oil filter, in the correct
direction, as shown on photo.
- Replace the cap and screw to 15 Nm
NOTE : The filter 6 must be replaced after
every oil change.
oil R4000 recommended by the manufacturer.
Fuel tank removal
1
2
- Unscrew the tank's central screw 1, and
the right and left lower inlet screws 2
3
Disconnect the fuel pump's wiring harness pin 3
101