Engine Oil; Checking Oil Level; Oil Change - Replacing Filter - SHERCO Enduro Manual Del Usuario

Checking oil level

Make sure that your bike is on its two wheels, vertical and on a horizontal surface.
Through the clutch sump window, check the level of engine oil as shown
in diagram 1
Adjust the level if necessary
!
Warning :
- Unscrew the filler cap 2 on the clutch engine oil sump,
- Top up using engine oil R4000 recommended by:
.
The wrong level of oil can damage your engine.
Do not use your bike if the level is below the minimum.
98

Engine oil

1
Level with engine warm
Level with engine cold
2
Oil change – replacing filter
The oil should be changed when the engine is warm.
!
Warning : Use protective gloves.
1
3
2
4
Clean the plugs 1 – 2 with solvent
Clean and inspect the pre-filter 3 and change it if necessary
!
Warning : The plugs must have new seals when they are replaced.
- Position the bike vertically on a horizontal
surface.
- Place a container under the bike to catch
the old oil.
- Unscrew the drain plug 1
- Unscrew the drain plug 2
- Remove the pre-filter 3
- Let the oil flow out
- Unscrew the oil filter cap 4
- Remove the oil filter
- Let the oil flow out
99