Festo SLTE Serie Instrucciones De Utilizacion página 27

SLTE−...
Please note
The reference point cannot be ascertained accurately if reference travel is made
against a rubber buffer in the fixed stop.
S Make sure that there is no rubber buffer in the fixed stop to which reference
travel is made.
Reference travel against a fixed stop 6:
Use a suitable tool (e.g. pliers or screw
S
driver) to remove the rubber buffer from
the fixed stop to which reference travel is
made. Dismantled rubber buffers should
not be used again. Two new rubber buffers
are included in delivery for cushioning the
end position again.
If the device is fitted in a vertical position,
reference travel against the upper fixed
stop is recommended due to the lack of
self−locking and the rubber buffer sould
remain in the lower fixed stop.
Reference travel against a reference switch:
Make sure that both rubber buffers are
S
situated as end position cushioning in the
fixed stops 6 (status as at delivery).
If necessary, press one of the rubber
buffers supplied into the empty holes of
each of the fixed stops.
Festo SLTE−... 0501NH English
Fig. 5
Fig. 6
27