Operation - Festo SLTE Serie Instrucciones De Utilizacion

SLTE−...
Please note
Reference travel against the end stop at high speeds can damage mechanical
components and connections.
S In the case of travel to the end stop, make sure that the maximum speed of
the reference travel (10 mm/s) is not exceeded.
1. Start a test run with the existing programmings.
2. Check to see if the following settings on the SLTE−... need to be modified:
Differing positioning accuracy or overswing of the system can possibly have
the following causes:
additional mass too high
feed speed too high.
3. If necessary, repeat the test run.
When all necessary corrections have been undertaken:
4. Conclude the test run.
7

Operation

Warning
S Make sure that:
nobody can place his/her hand in the
path of the moveable mass (e.g. by
providing a protective screen),
there are no objects in the path of the
moveable mass.
It must not be possible to touch the
SLTE−... until the mass has come to a
complete stand.
32
Fig. 15
Festo SLTE−... 0501NH English