Festo SLTE Serie Instrucciones De Utilizacion página 30

SLTE−...
Protecting the end positions against uncon
trolled overrunning:
Take into consideration the fact that soft
S
ware end positions in the SFC−DC can be
set.
Make sure that the controller is switched
S
off.
It is not sufficient just to cancel the enable
signal to the controller.
Connect the SLTE−... to the controller completely at connection 5
S
(compare Fig. 12).
Use the original connecting cable from Festo in accordance with the chapter
S
Accessories".
Pin Connection
1 Motor +
2 Motor −
3 A
4 A/
5 B
6 B/
7 I
8 I/
9 +5 V DC (± 5 %)
10 GND
11 NC
12 NC
Fig. 13
30
Designation
Motor conductor
Motor conductor
Encoder signal RS485
Encoder signal RS485
Encoder signal RS485
Encoder signal RS485
Encoder signal RS485
Encoder signal RS485
Signal supply
(max. 50 mA)
Signal ground
Pre−assigned
Pre−assigned
Fig. 12
M12 plug connector on the
SLTE−... (12−pin, view onto
plug pins)
Festo SLTE−... 0501NH English