Anterior Mounting Block - Permobil BODILINK Guía De Usuario

INSTALLATION - ANTERIOR MOUNTING BLOCK
For back supports where threading from the anterior
surface of the shell is necessary or preferred.
D
E
F
For AGILITY and other OEM back supports that have a 2-hole head support
mounting pattern. Instructions should be used with the images above.
1
Loosen the screws (D) with the 4mm hex key and remove along with the
washers (E) and the spacer plate (F) from the mounting block (B).
2
Use the provided flat head screws* (H) with the countersunk holes in the
spacer plate (F) to attach it to the mounting block (B). Make sure that the
screw heads are flush with the spacer plate (F) when tightened.
*M6 X 1 X 14mm flat head cap screws
3
Align the remaining threaded holes (J) on the spacer plate with the holes on
the back support.
4
Attach, using the provided shorter button head screws (not shown)** and
the existing washers (E).
**M6 X 1 X 8mm button head cap screws
Note: See SUPPORT PAD installation, positioning and adjustment instructions in this
manual to make final adjustments.
BodiLink Head Support User Guide & Manual
1
C
B
A
1
If the head support hardware stem (C) is inserted into the
mounting block (B), turn the knob (A) counterclockwise to
release it and set it aside.
2
Loosen the buttonhead screws (D) with the 4mm hex key and
remove along with the washers (E) and the spacer plate (F)
from the mounting block (B).
3
Remove the back support cover (not shown) allowing access
from both sides to the head support holes on the back
support shell (G).
4
Align the mounting block (B) and the spacer plate (F) with the
available head support holes on the back support shell (G).
5
Attach (B) and (F) with the screws (D) and the washers (E)
from the front face of the back support shell (G) and tighten.
6 Replace and secure the back support cover.
7
Insert the hardware stem (C) into the mounting block (B) and
turn the knob (A) clockwise to secure.
IMPORTANT! Make sure that at least ½" of the hardware
stem (C) is completely through the bottom of mounting block (B)
at all times. See the warning in the "Important Safety
Information" section in this manual.
See SUPPORT PAD installation, positioning and adjustment
instructions in this manual to make final adjustments.
D
E
6
G
F
F
B
2
J
B
H