General Information; Wall Control Installation; Upper Canopy - Emerson HF948BS02 Manual De Instrucciones

5. How to Wire Your Ceiling Fan
5.5
Slide the upper canopy up the rod within 1/4" of the ceiling
or beam and securely tighten the setscrew (Figure 19).
6.1

General Information

The SW95 Wall Control is designed to operate only
one ceiling fan, and Not an accessory light kit.
The SW95 Wall Control is rated for 1.25 Amp, 120
VAC, 60 HZ full load.
All ceiling fans must be completely installed before
installation of the Wall Control.
Your new Wall Control will require a grounded
electrical supply line of 120 volts AC, 60 HZ circuit.
NOTE: Do not install a solid state electronic romote
control with the SW95 wall control installed, damage
to the fan motor could result.

6. Wall Control Installation

Figure 19
6.2
Installation of Wall Control replacing an
Existing Wall Control:
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to install the
ceiling fan mounting plate on the outlet box.
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse box before wiring. All wiring must be in
accordance with National and Local codes and the ceiling
fan must be properly grounded as a precaution against
possible electrical shock.
Please contact 1-800-654-3545 for further assistance
13
(Continued)

UPPER CANOPY

SETSCREW
WARNING
emersonfans.com
U.L. Model No.: HF948 & HF956