Tools Needed For Assembly; Electrical Requirements; Important - Emerson HF948BS02 Manual De Instrucciones

1. Unpacking Instructions
This Manual Is Designed to Make it as Easy as Possible for
You to Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One stepladder
One wire stripper
Materials
Drill
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be a
3-conductor (2-wire with ground) of following size:
Installed Wire Length
Up to 50 ft.
50-100 ft.
IMPORTANT: Your ceiling fan will not function
properly, and may be damaged, if used with any wall
dimmer switch or control other than an Emerson
Electric Fan Wall Control.
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
WARNING
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse box before wiring. All wiring must be in
accordance with National and Local codes and the ceiling
fan must be properly grounded as a precaution against
possible electrical shock.
Wire Size A.W.G.
14
12

2. Electrical Requirements

(Continued)
!
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 11). If you feel
you do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
!
To avoid fire or shock, follow all wiring instructions
carefully.
Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
Please call Emerson
1-800-654-3545 if you have any questions about
installation and operation of this ceiling fan.
4
WARNING
WARNING
technical support
U.L. Model No.: HF948 & HF956
at