6. Wall Control Installation
6.3
Remove the faceplate and the two 6-32 screws from the
existing wall switch (retain faceplate and screws for future
use) (Figure 20).
6.4
Pull existing wall switch out from the wall outlet box.
Disconnect the existing wall switch wires from the wires in
the outlet box by removing the the two wire connectors
(discard connectors) (Figure 21).
6.5
Set the new Wall Control in the OFF position (full counter-
clockwise) (Figure 22).
Pull the knob of the Wall Control (retain for future use).
(Continued)
WALL OUTLET BOX
SWITCH
6-3 SCREWS (2)
Figure 20
WALL OUTLET BOX
WIRE
CONNECTOR (2)
Figure 21
SCREWS (2)
KNOB
WALL CONTROL
Figure 22
14
FACEPLATE
NEUTRAL LEAD WIRES
EXISTING WALL SWITCH
U.L. Model No.: HF948 & HF956