Clevis Pin; Hairpin Clip - Emerson HF948BS02 Manual De Instrucciones

3. Ceiling Fan Assembly
3.4
Seat the hanger pipe in the motor yoke (Figure 4).
3.5
Align the clevis pin holes in the hanger pipe with the holes
in the motor yoke.
Install the clevis pin and secure with the hairpin clip (Figure
5).
The clevis pin must go through the holes in the motor yoke
and the holes in the hanger pipe.
Push the straight leg of the hairpin clip through the hole
near the end of the clevis pin until the curved portion of the
hairpin clip snaps around the clevis pin.
The hairpin clip must be properly installed to prevent the
clevis pin from working loose.
Pull on the rubber grommet to make sure the clevis pin is
properly installed.
WARNING
!
It is critical that the clevis pin in the motor coupling is
properly installed. Failure to verify that the pin is properly
installed (as shown in Figure 5) could result in the fan
falling.
(Continued)
CANOPIES NOT SHOWN
FOR CLARITY
Figure 4
CANOPIES NOT SHOWN FOR CLARITY
HAIRPIN
CLIP
MOTOR YOKE
Figure 5
6
HANGER PIPE
MOTOR YOKE
RUBBER
GROMMET
HANGER PIPE

CLEVIS PIN

U.L. Model No.: HF948 & HF956