Resetting The Device To The Factory Settings; Adjusting Grinding Fineness - melitta CAFFEO Manual De Instrucciones

• Press the on/off button
→
Depending on the selection 1 to 3 bean symbols
display. The appliance is in stand-by mode again.

Resetting the device to the factory settings

Follow the instructions below to reset the CAFFEO
Prerequisite: The appliance must be in stand-by mode.
•
Switch the device off via the power switch.
•
Wait until the red light in the on/off button
•
Simultaneously press the button for coffee strength
two-cup dispensing
•
At the same time switch the power switch on again.
→ All settings are reset to the factory settings.
Adjusting grinding fineness
The grinding fineness level was optimally adjusted prior to delivery. Consequently, we
recommend that you only readjust grinding fineness after approximately 1,000 coffee
preparation processes.
You can only set the grinding fineness while the grinder is running. Thus, adjust grin-
ding fineness directly after coffee dispensing starts.
If the coffee flavour is not sufficiently intense then we recommend the fine grinding
level.
•
Place the lever (Fig. B, no. 19) in one of the three positions
(as viewed from the rear of the appliance).
Lever position
left
middle
right
62
to confirm the selected brewing temperature.
.
Grinding fineness
finer
medium
coarser
will be flashing in the
to the factory settings:
®
goes out.
and the button for