Adjusting The Timer For Stand-By Mode - Function Setting 3 - melitta CAFFEO Manual De Instrucciones

Display
• Press the on/off button
→
Depending on the selection 1 to 4 bean symbols
mation. The appliance is in stand-by mode again.
Note
Press any button to wake the machine out of energy-saving standby mode.
The function of the pressed button (e.g. prepare coffee) will be directly
executed, only the heat-up phase will last somewhat longer.
Adjusting the timer for stand-by mode
– function setting 3
Additional information on stand-by mode is provided on page 58.
The timer is factory-set to level 2 (2 hours).
Please adjust the timer as follows:
Prerequisite: The appliance must be in stand-by mode.
→
The on/off button
• Simultaneously press the button for single-cup dispensing
ton for steam dispensing
•
Press the button several times for two-cup dispensing
ween four possible times for the timer.
→ The button for two-cup dispensing
→ Your selection is indicated by the bean symbols
60
Time
5 minutes
15 minutes
30 minutes
off
to confirm the selected time.
will be illuminated red.
, until the four buttons are faintly illuminated.
is brightly illuminated.
will be flashing as confir-
and the but-
, to select bet-
in the display.