EB TECHNOLOGY START S10 Instrucciones Y Advertencias Para El Instalador página 29

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

2.5
Scheme of the control unit and electrical connections
P1
P2
P3
433,92 Mhz
Radio receiver
FCC2
FCA2
FCC1
FCA1
FOTOA
FOTOB STOP
START
PED
1 2 3 4 5 6 7 8 9 10 11 12
SET UP OF THE CONTROL UNIT
To program the control unit press P1, the gate must be closed (if you
press P1 when the control unit is turning on. It leaves the function
before the turning off)
Use P2 or P3 to select different groups T, L, S, C, R, or select E
to go back to the standard function. The control unit will reset all
functions and go back to the normal status after 60 seconds which
is unsed.
Press P1 to confirm the operation, P2 and P3 to choose the set up,
if you need to go back to the group of set up press P2+P3
WHEN THE CONNECTION IS FINISHED
When the connection is finished, check the motors as shown in
the Par. 4.2 Function R. Then before the memorization of the
working time, set up the speed, obstacle detection and activation/
deactivation of the inputs.
Tension for accessories,inputs , services and safeties
1  18
19  22
Power supply of the motor
23  30
Power supply of the control unit, Battery
J12/24
Selection of the 12/24V power supply
P1 P2 P3 Buttons to reset the control unit
F1
Fuse for Transformer power supply - 3,15 A
F2
Fuse power supply, accessories and logic - 1,6 A
F3
Fuses for power supply of the motors
J12/24
F3
F2
23 24
13 14 15 16 17 18 19 20 21 22
F1
25 26
27 28 29 30
Rit.
- 8 A
+ Antenna
Common Services and Safeties
Common Services and Safeties
Closing limit switch 2
Opening limit switch 2
Closing limit switch 1
Opening limit switch1 -7-
Partial opening
- Common for accessories
+ Power supply for accessories
- LAMP OR COURTESY LIGHT
- ELEC. KEY LOCK
Read Paragraph 3.2 to
check the right direc-
tion of the motors.
- BATTERY
+ BATTERY
Input for LOW TENSION
Input for LOW TENSION -26-
230 Vac input
230 Vac input -28-
Output for power supply -29-
Output for power supply -30-
Mechanical edge: NC/8k2 -31-
Mechanical edge: NC/8k2 -32-
5
-1-
-2-
-3-
-4-
-5-
-6-
Photo A
-8-
Photo B
-9-
Stop -10-
-11-
Start
-12-
-13-
-14-
- LIGHT
-15-
- TEST
-16-
-17-
-18-
MOT 2
-19-
MOT 2
-20-
MOT 1
-21-
MOT 1
-22-
-23-
-24-
-25-
-27-

Publicidad

Tabla de contenido
loading

Tabla de contenido