EB TECHNOLOGY START S10 Instrucciones Y Advertencias Para El Instalador página 32

8
3.10 Connection of the LIMIT SWITCHES
In the picture is shown the connection of both limit switches but in this control unit you can use separately.
So you can use only OPENING limit switches or only CLOSING limit switches.
To deactivate the input LIMIT SWITCHES do as shown in the table
Set up Value
S 11 0
S 12 0
3 4 5 6
mOT 2
CLOSE
3.11 Connection of an OPENING CONTROL / START / PARTIAL OPENING
3 4 5
If you use the terminal boards no.3 and no.11 it is possible to connect a TIMER to program the opening time of the gates.
The contact should be normally open and it is closed for all the time the gate is open. If the connection with the opening
gates is available in the terminal board no.16, connect it in parallel.
Description
Deactivation of
Standard
the input opening
limit switch 1
Deactivation of
Standard
the input closing
limit switch 1
7 8 9 10 11 12
OPEN
6 7 8 9 10 11
Set up
S 13
value 1
S 14
value 1
MOT 1
CLOSE
The connection of a PARTIAL OPENING can be
12
done with every button or a normally open contact.
The connection of a START can be done with every
button or a normally open contact. If more devices are
available, they should be serial connected.
Value Description
Deactivation of
0
the input opening
limit switch 2
Deactivation of
0
the input closing
limit switch 2
The limit switches
contact should
be normally closed.
OPEN
Standard
value 1
Standard
value 1