EB TECHNOLOGY START S10 Instrucciones Y Advertencias Para El Instalador página 33

3.12 Connection of the PHOTO A (only closing)
2 3 4 5 6
3.13 Connection of the PHOTO-BEAM FOTO A (only closing) with PHOTO-TEST
2 3 4 5 6
The PHOTO-TEST check the right working of the gate if the photo-beams are working properly. The control unit will do a
test before the gate opening.
In case the photo-beams are not working properly, the lamp will be turned on and the gate is not working.
To activate the TEST put at 1 the PHOTO A:
If you don't need the PHOTO-TEST, connect the photo-beams (see Par. 3.2) and put at 0 in the function S22 and S06
(S06 should be deactivated only when other TEST are not available)
7 8 9 10
POWER SUPPLY OF
THE PHOTO-BEAM
-
+
Photo-beam receivers.
N.C. terminal board.
7 8 9 10
POWER SUPPLY OF
THE PHOTO-BEAM
-
+
Photo-beam receivers.
N.C. terminal board
Set up
S 06
S 22
13 14 15 16
- +
+
-
POWER SUPPLY OF
THE PHOTO-BEAM
13 14 15 16 17
- + -
POWER SUPPLY OF
THE PHOTO-BEAM
Value Description
Activate the TEST
1
output for INPUT TEST
(Val. Default 0)
To activate the TEST
1
put at 1 the PHOTO A
(Val. Default 0)
The normally closed contact of the
receiver should be isolated from
tension.
If you you more couples of photo-
beams the connection should be
serial.
If the input FOTO
is not used,
put the S16 at " 0"
The normally closet contact of the
receiver should be isolated from
tensions.
If you you more couples of photo-
beams the connection should be
serial.
If the input FOTO
is not used,
put the S16 at "0"
9