EB TECHNOLOGY START S10 Instrucciones Y Advertencias Para El Instalador página 34

10
3.14 Connection of the PHOTO-B (in opening and closing)
2 3 4 5 6
3.15 Connection of the PHOTO-BEAm B (opening and closing) with TEST
2 3 4 5 6
The PHOTO-TEST check that the gate is working only if the photo-beams are working properly.
The control unit will do a general test before opening.
In case the photo-beams are not working properly, the signal light will turn on for 5 seconds and the gate is not working
To activate the PHOTO-TEST put at "1" the set up of the photo-beams PHOTO-B:
If you want to go back to the function without PHOTO-TEST, connect the photo-beams as shown in the Paragraph 3.14 and
put the function S23 and S06 at "0" (deactivate the S06 only when other inputs have no TEST)
7 8 9 10
POWER SUPPLY
OF THE RX
Photo-beam receivers.
N.C. contacts.
7 8 9 10
POWER SUPPLY
OF THE RX
Photo-beam receivers.
N.C. contacts.
Set up
S 06
S 23
13 14 15 16
- +
+
-
POWER SUPPLY
OF THE TX
13 14 15 16 17
- + -
POWER SUPPLY
OF THE TX
Value Description
Activate the TEST
1
output for INPUT TEST
(Standard Value 0)
Activate the input TEST
1
for PHOTO-B
(Standard Value 0)
The normally closed contact of the
receiver should be isolated from
tensions.
If you you more couples of photo-
beams the connection should be
serial.
If the input PHOTO-STOP
is not used,
put the S17 at "0"
The normally closed contact of the
receiver should be isolated from
tensions.
If you you more couples of photo-
beams the connection should be
serial.
If the input PHOTO-STOP
is not used,
put the S16 at "0"