EB TECHNOLOGY START S10 Instrucciones Y Advertencias Para El Instalador página 36

12
4 Function and adjustment
Check the right function of the motors and the accessories as shown in the par. 4.2 and then, if you don't know the working
time of the motors, program the speed (see Par. 4.4), obstacle detection (see Par. 4.5) and activation/deactivation of the
inputs.
4.1 Function
Set up
S 01 1
2
3
4
5
6
S 02 1
S 04 1
S 19 1
S 07 1
S 09 1
S 10 1
Function
Fast reverse
(Standard value)
Collective use
Step-by-step function
Step-by-step
with automatic re-closing
after pause time
Industrial use
man present function
Reclosing
when turning off
(Default 0)
Passage control
(Default 0)
Riverse at
the passage check
(Default 1)
Fixed Light
(Default 0)
Activation of soft-start
(Default 0)
ONE mOTOR function
(Default 0)
Description
By each control it riverse: open-close
When opening and pause time it doesn't accept any control, it
re-close automatically.
Each control it follows each: open-stop-close-stop-open
No automatic reclosing
By each control it follows open-stop-close-stop-open.. It reclu-
ses automatically after the pause time.
The PARTIAL OPENING control has a closing function, too while
START follow the logic of dip1 and dip 2
The START control opens, the PARTIAL OPENING closed. The
motors stop after the button will be released.
Make a complete opening and closing cycle, only in case the
tension has been broken, when the gate was open.
When the photo-beams realize the passage, if S19 has value 0,
the pause time is 2sec.
Put S04 at 1. When the function is activated and the gate is
opening, the control unit reverse the direction of the motors
and close.
The light is lit on when the gate is open.
The motors have minimum values until the settled values.
If you put at 1 the S10, the control unit can synchronise the move
of the motors. The working time memorization will be done only
for motor no.1