Vinten Osprey light Manual Del Usuario página 19

English
Stop pumping when the required pressure is reached (Fig 4) during the pumping stroke. Do not
exceed the maximum working pressure, indicated by the leading edge of the red sector on the
gauge (2).
NOTE: Do not exceed 3.5 bar (50 psi) if the pan and tilt head has yet to be fitted. For further
information refer to 'Fitting and balancing the load' on page 19.
Fully collapse the moving column (5) and apply the safety catch (24).
Set the control valve (26) to the TRANSITION position as follows:
Depress the control valve (26) against the spring force, rotate the lever to the vertical po-
sition and allow the lever to extend under the spring force.
WARNING!
Set the control valve (26) to the WORK position as follows:
Ensure the moving column (5) is fully collapsed and the safety catch (24) is applied.
Depress the control valve (26) against the spring force, and rotate the lever fully counter
clockwise to a horizontal position, allowing the lever (26) to extend under the spring force.
The control valve (26) will remain in an extended position.
Pressurizing the pedestal using the Vinten portable pump
To pressurize the pedestal using the Vinten portable pump, proceed as follows:
Fully collapse the moving column (5) and apply the safety catch (24).
Set the control valve (26) to the WORK position (refer to 'Setting the control
more detail).
Rotate the steering ring (3) so that the pressure gauge is visible through the viewing window (2).
On the pump (Fig 4), fold down both the feet (P.3).
Depress the handle release button (P.5) and move the handle (P.1) to the horizontal position,
where it will lock.
Pull the hose (P.4) out of its stowage (P.2). Connect the hose to the pedestal charging valve.
Position the pump between the legs, standing with both feet on the fold-down feet (P.3).
Grip the handle (P.1) with both hands and, using full steady strokes, pressurize the pedestal to the
required pressure. Do not exceed the maximum working pressure, indicated by the leading edge
of the red sector on the gauge (2).
NOTE: Do not exceed 3.5 bar (50 psi) if the pan and tilt head has yet to be fitted. For further
information refer to 'Fitting and balancing the
18
Place the control valve (26) in the TRANSITION position for at least 10-
SECONDS when switching between PUMP and WORK modes, to prevent
the moving column (5) rising rapidly.
load' on page 19.
valve' on page 15 for